Building the board

I will give it a try and show how the first of four was made. The yellow foam board’s strenght is 2cm, the green’s 6mm and the wood’s 6mm, too.

First Babysteps

First Babysteps

Two wooden houses made the start. The right one already shows the glued on 6mm foam board and the carved lines which were made with a regular pencil.

Two wooden houses made the start. The right one already shows the glued on 6mm foam board and the carved lines which were made with a regular pencil.

Here the whole board is finished minus the top houses.

Here the whole board is finished minus the top houses.

Now follows a step by step documentation about the first completed house. First it started with a wooden core again.

Now follows a step by step documentation about the first completed house. First it started with a wooden core again.

The next step was to glue on the foam board.

The next step was to glue on the foam board.

The last step was to carve in the buildings structure. After that the lower parts needed some pressure with the rubberback of the pencil to achieve the cracked deeper structure. Also the rooftop was made out of corn flakes board and finaly some bits were added.

The last step was to carve in the buildings structure. After that the lower parts needed some pressure with the rubberback of the pencil to achieve the cracked deeper structure. Also the rooftop was made out of corn flakes board and finaly some bits were added.

The first gaming board was sanded and later on ready for the primer.

The first gaming board was sanded and later on ready for the primer.

The last three pictures show the other three gaming boards in different WIP-status:

Leave a reply